How To Service My Printer - MISS / CISS single printer installation guides

 
Step by step instructions

1. Open the front cover
2. open the ink cartridge locking cover, put the cartridge, close the cartridge locking cover
3. Stick the tube using double side tape, use cable tie to tie up the tube, and cut the extra cable tie
4. Stick the tube on the printer
5. Do cleaning process to make sure perfect print

How To Service My Printer - MISS / CISS single printer installation guides

Read more

How To Service My Printer - MISS / CISS Ink for Multifunction Printers installation guides

How To Service My Printer - MISS / CISS Ink for Multifunction Printers installation guides

• lift the scanner unit
• open the ink cartridge locking cover, put in the  cartridge and close back
• stick the tube support in the middle of printer
• move the cartridge left and right to test smoothness of the tube movement
• stick the clincher A and B to the tube
• do cleaning process to make sure prerfect print

 

Read more

How To Service My Printer - Maxprint Printer Guide for Multifunction Printers

 

How To Service My Printer - Maxprint Printer Guide for Multifunction Printers

MISS Guides

• Place the printer appropiate place
• open the ink cover and close it back please refer picture above
• dont raise up the ink system
• always turn on your printer 
• please see picture above for error code display at your printer
• tqvm

Read more

Printer says E3 and Printer Status there is a Paper Jam :(

In my case “E3” (paper jam error) was caused by a hidden tack pin that had fallen into the printer where the paper is loaded. The pin was lodged between the grey paper pickup roller and a tiny black plastic sensor in the back of the printer. The sensor’s function is to detect paper under it. One can turn the printer upside down and genitally giving the printer a little shake to try and dislodge any obstructing objects. Be careful not to let scanner bed flop open or you might damage the printer
I have found dead moths, lady bugs, cedar bugs, staples, paper clips, food, and tack pins in various printers which I have serviced. 

Read more

How To Service My Printer - Error Code for Canon PIXMA MP287

 



















P02 – Carriage Error, there is something wrong with your printer ink cartridge, it could be in wrong position, something blocked the chip (see at the back of cartridge), also P02 error code show sign that your print head is broken or faulty, try to take out both of the cartridge and then put it back.

P07 – Ink Absorber Is Full or Almost Full, you need to reset your printer, here is an article how to reset your canon mp287 printer. Follow the step, you can reset only if your absorber is almost full. You can’t reset if your ink absorber is full, to fix the absorber is full, you need to disassemble your printer and then replace the ink absorber (it’s just a pieces of sponge located in the printer), last time I just deep the sponge into water until the sponge is clean. I found a video but for MP258, the sponge located at the same position.

Read more