When the MP287 is turned on, it will immediately appear on the LCD panel error E08 MP287. And when we do print command, then the monitor screen will show “The Ink Absorber is Almost Full”. Caption MP287 E08 error on the screen as follows:
- Turn on the Canon MP287, MP287 LCD then the panel will pop up error E08, and there is a description of “The Ink Absorber is Almost Full” on the screen of your monitor.
- Download Resetter MP287 at this link http://www.mediafire.com/?esuhhe214i1dd6t
- Canon MP287 printer must be in a state of SERVICE MODE. Do I read the next step.
- Canon MP287 Turn off the E08 error by pressing the power. Do not unplug the power cord.
- Press and Hold the button STOP / RESET followed by pressing the POWER button. So both buttons depressed position.
- Release the button STOP / RESET but do not release the button POWER.
- In these circumstances the POWER button is still depressed, press the STOP / RESET 6 times.
- Then release both buttons simultaneously. Then the Canon MP287 will be in Service Mode condition.
- LCD Panel MP287 will blank / dark and in your computer will detect new hardware. Ignore it.
- The next step Exctract and Run Service Tool for MP287 MP287 E08 error you downloaded earlier.
- Click the “PLAY”, then the printer will proceed, then MP258 will print one page with the words “D = 000.0″
- Click “Clear EEPROM”.
- Then click “EEPROM”, and the printer will print the results MP258 Resetter. Writing one line as follows: “TPage (COPY TTL = 00 000 = 00 000)”.
- Canon MP287 Turn off by pressing the power.
- Canon MP287 printer that error E08 will be normal again.
mengapa service tools yg saya download untuk printer mp287, setelah saya jalankan , dan ikuti semua petunjuk , tetapi printer tidak ada respon
mohon dibantu
trimakasih
salam
arthana
ada gak yang xjadi sebab board problem..nanti saya cuba cari manual dan service tool yang lain..
Hi u provide me the best way for my ink cartridges for printers.much more related to printer troubleshooting and e.t.c thanks and hope u will continuously going on your way for providing me best information
the resetter tool hang when I try to follow your instructions. what should I do..?
where we fine the services tool
this resetter and service mode procedure only works with error p07(absorber full error), not work with e08(absorber almost full error), for e08 error just press START button when error appear..
Thank you very much. your information.
I'm successed !!
Ass..mohon bantu gan, printer saya MP287 pada saat dihidupkan hanya nyala/on sebentar setelah itu langsung mati seperti tidak ada power..mohon bantuannya gan...trima kasih
when i tried to enter service mode the computer detects it as CanonDevice.. tried it on winxp and win7 same thing...