Printer Canon Pixma MP258 – Absorber Full

Printer Canon Pixma MP258 – Absorber Full

If your printer show P07 error it means that your ink absorber inside the printer is almost full. In order to solve this you need to clear or reset the counter protection of your printer. To do this, follow this steps.

First make sure that the power cable and usb cable are connected, before you perform the reset procedure. And download the resetter at the bottom of this post.

FIRST STEPS:  Entering Service Mode

You have to enter in service mode in order to used the resetter. To do that follow this procedure,

1. Turn off the printer without pulling the power cords.

2. Hold down STOP/RESET button and press Power button.

3. Keep holding down Power button and let STOP/RESET button go.

4. Then Press STOP/RESET button twice then let BOTH buttons go.

5. You will notice that the Alternate Blinking error is gone, this means that the printer is in Service Mode state.

SECOND STEPS: Using the Resetter

1. After you download the resetter, extract it and double click "servicetool.exe"

2. Load some papers in your printer and press the "Main" Button once, wait until the printing is done.

3. Then press "EEPROM Clear" button to clear EEPROM.

4. Then press EEPROM button and the printer will print some text.

5. Then power off the printer(sometimes you have to press twice the power button to turn off) and turn on again. and its done!

GFCH5V82RBB9 

Read more

Printer Canon Pixma MP258 – Error P08

First time, I found the problem Canon Pixma MP258 printer will not print from the cpu or the Copy Scan and P08 are the error messages on the printer panel. I could maybe try to reset, e turned out to be, then I created to copy directly, it was also error.

I've lost both cartridges, the ink was discharged, directly, I refill the black  and a color cartridge. Then I do a test print and the result is smooth and good wow.

If this error P08 does not clear, please 

Follow the instructions step by step

1. Turn off printer, cable power still plug in,
2. Press Stop/Reset button  don't release
3. Press Power Button don't release and than release Stop/Reset button
4. Press Stop/Reset button 2X and than release Power Button, wait until service mode to " 0 "
5. Turn off printer, cable power still plug in
6. Press Stop/Reset button  don't release
7. Press Power Button don't release and than release Stop/Reset button
8. Press Stop/Reset button 4X and than release Power Button, wait until service mode to " 1 "
9. Turn off printer, and loose cable power, wait one minute.
10. Connect cable power, turn on printer again, now this printer ready to use.

Read more